Bang & Olufsen ML Gateway Guide d'installation télécharger pdf (Page 46)

Supported devices 46

Vantage

Connection to a Vantage system

Communication with a Vantage system is done through an InFusion Dim Controller. This device has both RS232 and Ethernet interfaces.

Connection to the RS232 interface can be done directly using a fully wired RS232 cable and it is xed at no parity, 1 stop bit, 8 data bits. Make

sure to congure bit rate and ow control as needed. Connection settings for Ethernet are the IP address of the InFusion Dim Controller and its

telnet port.

Dening Vantage resources

To program the InFusion Dim Controller, the PC tool Design Center is needed. It lets you dene all components of your Vantage system, where

each one has an address called VID (Vantage Identication Number).

On MLGW you can dene as resources either a button on any control, or a task. To dene a resource, you need to know the Button or Task vid,

wich must be entered in the ID eld.

Vantage events and commands

An event corresponds to a Button press or release, or a Task activation or deactivation. Supported commands are Button press and release,

Button press, Button release and Task activation.

1 2 ... 41 42 43 44 45 46 47 48 49 50 51 ... 57 58

Pas de commentaire

Bang & Olufsen ML Gateway Guide d'installation Page 46