Bang & Olufsen ML Gateway Guide d'installation télécharger pdf (Page 25)

Programming 25

To terminate product assignment click the End product assignment button, or press the setup

button on the front panel (or wait for 5 minutes timeout).

To abort, click the Abort product assignment button, or press and hold the setup button on

the front panel for 3 seconds.

Assign single product:

- Navigate to Programming -> Devices -> Beolink products

- Use the drop down box to choose the product to assign

- Click the Assign single product... button

- Activate the product, by selecting a source, to switch on the product. Remember:

! Main products can be activated by selecting any source

! Link products must be activated by selecting a source from the main room

(do not use local sources)

To abort, click the Abort product assignment button, or press and hold the setup button on

the front panel for 3 seconds.

Note!

- There are limitations to BeoLink Wireless products. ML Gateway has no way of distinguishing between different units in a wireless setup, therefore

you cannot identify them individually.

- If more products are activated during product assignment than have been dened on the Resources screen, these are added as new resources

automatically.

- Product assignment can be started from the front panel (see link), without using the web interface. This can be useful for ML Gateway protocol-

only installations where no further setup is needed.

! During product activation, main products in link rooms (i.e. in Options 5 or 6) must be activated using a source from the main room (not a source

local to the product). Otherwise ML Gateway will not receive feedback from that product.

- When the product assignment procedure is completed, continue to setting up sources on the next page.

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 57 58

Pas de commentaire

Bang & Olufsen ML Gateway Guide d'installation Page 25